NPT- National Pipe Taper Threads - ANSI B1.20.1

NPT pipe threads - dimensions according ANSI/ASME B1.20.1

Sponsored Links

Common American National Standard Pipe Taper Threads

NPT - National Pipe Taper Thread
FPT - female (internal) National Pipe Taper threads
MPT - male (external) National Pipe Taper threads
NPTF - Dryseal American National Standard Taper Pipe Thread (ANSI B1.20.3)

For NPT threads a sealant compound or Teflon tape must be used for a leak-free seal. For NPTF no sealant is needed for a sealing.

Characteristics of NPT (also known as ANSI/ASME B1.20.1 Pipe Threads, General Purpose):

tapered thread 1^o 47'
truncation of roots and crests are flat
60^o thread angle
pitch is measured in threads per inch

Note! Pipe sizes do not refer to any physical dimensions. The outside diameter of a pipe or fitting must be measured and compared to a table for size identification. A 3/4" NPT pipe thread has an outside diameter - OD - of 1.050 inches.

Each thread size has a defined number of threads per inch - TPI, or pitch. The 3/4" NPT pipe thread has 14 threads per inch. Both the TPI and OD of the thread are required for positive identification of thread size because more than one size have the same TPI.

NPT - American Standard Pipe Taper Thread ¹⁾
Pipe Size (inches)	Threads per Inch TPI - pitch	Outside Diameter OD (inches)
1/16"	27	0.313"
1/8"	27	0.405"
1/4"	18	0.540"
3/8"	18	0.675"
1/2"	14	0.840"
3/4"	14	1.050"
1"	11-1/2	1.315"
1-1/4"	11-1/2	1.660"
1-1/2"	11-1/2	1.900"
2"	11-1/2	2.375"
2-1/2"	8	2.875"
3"	8	3.500"
3-1/2"	8	4.000"
4"	8	4.500"
5"	8	5.563"
6"	8	6.625"
8"	8	8.625"
10"	8	10.750"
12"	8	12.750"
14"	8	14.000"
16"	8	16.000"

¹⁾ The taper is 1/16 inch in an inch, which is the same as 3/4 inch in a foot (angle 1^o 47')

NPT threads are not interchangeable with NPS - National Pipe Straight - threads.

NPT threads may look similar to ISO 7/1 threads. However, ISO and NPT threads should not be mixed. ISO threads have 55^o taper angle versus 60^o for NPT. The NPT root and crest configurations are also different from ISO. For ISO threads pitch is usually measured in millimeters (may be expressed in Inch). The pitch are different.

ToolBox ShortList

Difficult to find your favorite ToolBox page? Add a link to the page in your own personal Shortlist!

• Add this Page! • Delete the ShortList!

Translate this page to Spanish French German Italian Dutch Norwegian

The content in The Piping ToolBox is copyrighted but can be used with NO WARRANTY or LIABILITY. Important information should always be double checked with alternative sources. All applicable national and local regulations and practices concerning this aspects must be strictly followed and adhered to.

We appreciate any comments and tips on how to make The Piping ToolBox a better information source. Please contact us by email if You find any faults, inaccurate, or otherwise unacceptable information.

5 12 1